Miele PW 6241 Operations Instructions download pdf (Page 39)

Electrical connection

All electrical work must be performed by a

qualified service technician in accordance with

applicable codes and standards.

When installaing a residual current device (RCD) a

Type B GFCI circuit breaker must be installed.

The connecting terminal is located behind a cover.

The machine must only be connected to the voltage

and frequency shown on the data plate.

The machine is equipped with a multi-tap

transformer.

Steam heated washers are factory set to

3 phase, 208 V, 60 Hz

They can be converted to

3 phase, 240 V, 60 Hz by a Miele Service Technician.

Electrically heated washers are factory set to 3

phase, 230 V, 50/60 Hz

They can be converted to

3 phase, 208 V, 60 Hz by a Miele Service Technician.

Equalizer

Secure the potential equalizer, if necessary.

To activate the heating the water level in the drum

must be 4

" (110 mm) high.

A motor overload protection is located in the motor

winding.

See the enclosed wiring and installation diagrams.

Steam connection

The steam connection must only be connected by a

certified installer. For more information see the

enclosed installation plan and the installation manual.

Connecting the dispensing pumps

The connecting terminal for 4 time controlled

dispensing pumps is located behind the cover next to

the electrical connection. See the supplied wiring

diagram.

The dispensing pumps can be operated without the

multifunction module.

Installation Instructions

1 ... 38 39 40 41 42 43 44

No comments

Miele PW 6241 Operations Instructions Page 39