Miele KM 6316 User Manual download pdf (Page 68)

Installing the hob

Preparing the worktop

^

Make the worktop cut-out according

to the dimensions given in the

building-in diagram. Remember to

maintain the minimum safety

distances (see "Safety instructions

for installation").

^

Seal the cut surfaces with a suitable

heat-resistant sealant to avoid

swelling caused by moisture.

Make sure that the sealant does not

come into contact with the top of the

worktop.

No spring clamps are needed to

install the hob. The seal underneath

the hob will hold it securely on the

worktop.

Any gap between the frame and

worktop will reduce with time.

Connecting the mains cable to the

appliance

The mains cable must only be

connected to the appliance by a

qualified and competent electrician

in strict accordance with current

local and national safety regulations

(BS 7671 in the UK).

^

Follow the instructions in the wiring

diagram (see "Electrical connection -

Wiring diagram").

Installing the hob

^

Feed the mains connection cable

down through the cut-out.

^

Place the hob centrally in the cut-out.

When doing this, make sure that the

seal under the hob sits flush with the

worktop on all sides. This is important

to ensure an effective seal all round.

Do not use sealant (e.g. silicone).

If the seal does not meet the worktop

correctly on the corners the corner

radius (ß R4) can be carefully

scribed to suit.

^ Connect the hob to the mains.

^ Check that the hob works.

Hob with frame or bevelled edge

68

1 2 ... 63 64 65 66 67 68 69 70 71 72 73 74 75 76

Comments to this Manuals

No comments