Miele H 4180 Operations Instructions download pdf (Page 63)

All electrical work should be

undertaken by a suitably qualified

and competent person in strict

accordance with current national

and local safety regulations

(BS 7671 in the UK).

Installation, repairs and other work

by unqualified persons could be

dangerous. The manufacturer

cannot be held liable for

unauthorised work.

Ensure power is not supplied to the

appliance until after installation or

repair work has been carried out.

The voltage and connected load are

given on the data plate, visible with the

oven door open. Ensure that these

match the household mains supply.

Please quote these data, and the model

and serial number when contacting the

Miele Service dept.

Connection of this appliance should be

made via a suitable isolator, which

complies with national and local safety

regulations, and the on/off switch

should be easily accessible after the

appliance has been built in.

If the switch is not accessible after

installation (depending on country) an

additional means of disconnection must

be provided for all poles.

For extra safety it is advisable to install

a residual current device with a trip

current of 30 mA (in accordance with

DIN VDE 0664, VDE 0100 Section 739).

When switched off there must be an

all-pole contact gap of 3 mm in the

isolator switch (including switch, fuses

and relays acc. to EN 60 335).

This device is intended for the

connection to a power supply system

with a maximum permissible system

impedance Z

MAX

of 0.42 Ohm at the

interface point (power service box) of

the user's supply.

The user has to ensure that this device

is connected only to a power supply

system which fulfillls the requirement

above. If necessary, the user can ask

the public power supply company for

the system impedance at the interface

point.

Important U.K.

This appliance is supplied with a 3-core

cable for connection to a single phase

230 V 50 Hz supply.

The wires are coloured in accordance

with the following code:

Green/yellow = earth

Blue = neutral

Brown = live

In other countries check these details

with your supplier.

WARNING

THIS APPLIANCE MUST BE

EARTHED.

Position of the data plate

Electrical connection

63

1 2 ... 58 59 60 61 62 63 64 65 66 67 68

Comments to this Manuals

No comments