Miele W 1918 Technical Information download pdf (Page 45)

Technical Information

W1900 Series Clothes Washers

5.13 Determining Which Electronic Requires Replacement

(Electronic Test Procedure)

Correct zero crossover point (NND) recognition is required by the

microprocessor to provide a reference point for activating relays and

thyristors. The zero crossover point of the sine wave is the basis for the

time measurement of the microprocessor.

If the Electronic Unit fails to detect the zero crossover of 3 half waves of

the AC power sine wave, a fault is registered and the microprocessor

resets. The current program is cancelled and the LED’s switch off. The

appliance can only be restarted after switching it off and then back on;

and selecting a program.

Because the possibility exists that either Electronic could present the

same type of fault condition; the following procedure ensures the correct

component is diagnosed / replaced.

Service Tip:

In the event the Control Electronic Unit or the Power Electronic Unit

is suspected to be faulty, this procedure must be performed.

Figure 5-10: Ribbon Cable with Pin 1 Position Noted

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 67 68

No comments

Miele W 1918 Technical Information Page 45