Miele G2142 User Manual download pdf (Page 56)

Waterproof system

All Miele dishwashers have a safety

valve located on the incoming water

line and a sealed underside with a

water sensor.

If a fault occurs, the water intake is

stopped and the drain pump is

activated. Water damage, if any, is

minimized.

Providing the dishwasher was installed

correctly by a Miele technician, the

waterproof system will protect you from

water damage throughout the lifetime of

the machine.

Connection to the water

supply

,Do not drink water from the

dishwasher!

– The dishwasher can heat its own

water to the temperature required by

the wash program. This allows for

connection of the machine to either a

hot or cold water source. For lowest

energy consumption connect the

dishwasher to a cold water source.

For fastest possible wash times, with

slightly higher energy consumption,

connect the dishwasher to a hot

water source. All programs use hot

water in the rinse cycles.

–

The inlet hose is approximately 5 ft.

(1.5m) long. A 5 ft. (1.5m) extension

hose is available from Miele.

–

The water inlet hose comes

equipped with a 3/4" female hose

thread connector. This can be

directly connected to a water supply

with 3/4" MHT (male hose thread

ends).

–

Water pressure: Must be between

4.5 - 145 psi (0.3 - 10 bar).

,

To prevent damage to the

dishwasher, it must only be

connected to a fully vented drainage

system.

,

Do not cut the intake hose. It

contains electrical wiring. If the hose

is cut, the dishwasher will not work.

There will be a water leak and you

could be injured. If the hose is too

long, coil it neatly and place it

behind the machine.

Plumbing

56

1 2 ... 51 52 53 54 55 56 57 58 59 60

Comments to this Manuals

No comments