Miele DA 269-4 Service Manual

Operating and installation instructionsCooker hoodDA 269-4To avoid the risk of accidentsor damage to this applianceit is essential to read theseinstru

Guide to the appliance10

a Extension pieceb Towerc Canopyd Touch controlse Grease filtersf Recirculation grille(only for recirculation mode)g Hob lightingh Charcoal filter(spe

The cooker hood works with. . . air extraction:The air is drawn in and cleaned by thegrease filters and directed outside.If the on-site ventilation sy

To switch the fan on^Press the On/Off control.The fan will come on at power level lI.If the cooker hood has beenconnected to a window contactswitch vi

Automatic switch-off of the IntensivesettingYou can set the Intensive setting so thatit only runs for 10 minutes beforereverting automatically to leve

Before any cleaning or maintenancework is carried out, disconnect thecooker hood from the mains supply.Ensure that:– it is switched off at the wallsoc

Important for appliances withlacquered housing(special order finish)It is very difficult to clean this type ofsurface without causing minor marks toth

Cleaning the grease filters in thedishwasher^Place the filters with the short sideupright in the lower basket, and washon a 65° programme using a mild

Changing a halogen lamp^Before any cleaning or maintenancework, disconnect the cooker hoodfrom the mains supply. Ensure that––it is switched off at th

1) Extraction2) Recirculation3) Ventilation grille positioned at the topfor recirculation4) and 5)The shaded areas represent the wall orceiling area f

Caring for the environment. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3Warning and Safety instructions . . . .

Assembly partsInstallation20

a 3 protective sheetsfor use when fitting the tower.b 2 hose clipsfor securing the exhaust ducting.c 1 reducing collarfor exhaust ducting C 125 mm.d 1

Before installation, it is important toread the information given on thefollowing pages as well as the"Appliance dimensions" and the"Wa

,Important: To avoid the dangerof toxic fumes, please observe theWarning and Safety instructions.This is especially crucial when usingthe cooker hood

Important:If the exhaust ducting is to run throughrooms, ceiling space etc. where theremay be great variations in temperaturebetween the different are

All electrical work should beundertaken by a suitably qualifiedand competent person in strictaccordance with current nationaland local safety regulati

The Miele DSM 400 Control module canbe used to combine the cooker hoodwith other components.It enables the following:Connection to a window contactswi

Connection to a light switchThe control module can be used toswitch on the cooker hood lighting via alight switch in the house.InstallationThe tower n

In the event of a fault which you cannotcorrect yourself, or if the appliance isunder guarantee, please contact:–Your Miele Dealer / Chartered Agentor

Total connected load...180W- Fan motor ...120W- Hob lighting ...3x20WVoltageUK,NZ,ZA...AC230VAUS...

Disposal of the packingmaterialThe transport and protective packinghas been selected from materials whichare environmentally friendly fordisposal, and

30

31

Alteration rights reserved / 1008M.-Nr. 07 259 020 / 00

This appliance complies with allrelevant local and national safetyrequirements. Inappropriate usecan, however, lead to personal injuryand damage to pr

~Before connecting the appliance tothe mains supply, make sure that thevoltage and frequency details given onthe data plate correspond with theon-site

~Do not connect the appliance to themains electricity supply by amulti-socket unit or an extension lead.These do not guarantee the requiredsafety of t

In order to ensure safe operation, andto prevent gases given off by theheating appliances from being drawnback into the room when the cookerhood and t

Correct use~Never use an open flame beneaththe cooker hood. To avoid the dangerof fire, do not flambé or grill over anopen flame under the cooker hood

~Safety regulations prohibit the fittingof a cooker hood over solid fuel stoves.~All ducting, pipework and fittingsmust be of non-flammable material.T