Miele T 8861 WP Edition 111 Operations Instructions download pdf (Page 43)

Installation site

,

The appliance must not be

installed behind a lockable door, a

sliding door or a door with a hinge

on the opposite side to that of the

tumble dryer, in such a way that a

full opening of the tumble dryer door

is restricted.

,

The cool air intake panel at the

front of the dryer must not be

blocked or covered, e.g. by a

laundry basket, as this would cause

a fault.

Building under a continuous

worktop/in a row of kitchen units

,

It is very important to avoid a

build-up of heat.

The warm air which is expelled from

the rear of the dryer must be able to

dissipate.

Warm air which cannot dissipate

could cause a fault.

A build-up of heat can be avoided by:

–

Adjusting the screw feet so that there

is a gap of at least 20 mm between the

floor and the bottom of the dryer.

–

Creating a gap for the dryer in the

kitchen furniture plinth facing.

–

Creating ventilation gaps in the

kitchen unit.

N.B. When built under, drying times

may be longer.

,

The dryer should not be installed

next to a refrigeration appliance. The

warm air expelled from the rear of

the dryer would increase the

temperature around the refrigeration

appliance's heat exchanger causing

the compressor to run continuously.

If it is not possible to install the dryer

anywhere else, then the refrigeration

appliance must be sealed off from

the dryer.

,

A building-under kit (Miele

accessory, available to order) with a

coverplate to replace the appliance's

lid is required if building under a

worktop. It must be fitted by a suitably

qualified person to ensure electrical

safety. The coverplate included in the

building-under kit replaces the

appliance's lid. It is necessary to fit the

coverplate for electrical safety

reasons.

–

Fitting instructions are supplied with

the conversion kit.

–

N.B. When built under, drying times

may be longer.

–

The electrical socket must be

located in an accessible position

near the machine.

Installation and connection

43

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 63 64

Comments to this Manuals

No comments