Miele KF 9757 iD User Manual download pdf (Page 19)

^

Press one of the temperature selector

buttons repeatedly until a

= appears

in the display. Then press the Super

freeze button again.

= lights up in the display.

^

You can now adjust the temperature

in the PerfectFresh zone by pressing

the temperature selector buttons. You

can choose from settings 1 to 9:

1: lowest temperature,

9: highest temperature.

= 5 is the default setting for the

PerfectFresh zone. If a setting of

= 1

to

= 4 is selected, the temperature

can fall below 0°C. Food could

freeze!

^ Press the Super freeze button to save

the setting.

^

Press the master switch on the right

hand side of the control panel to

come out of the setting mode.

Otherwise the electronics will revert

to normal operation after a couple of

minutes.

The new temperature setting for the

PerfectFresh zone takes effect

gradually.

Temperature display

During normal operation, the

temperature displays on the control

panel show the temperature in the

middle of the refrigerator section and

the temperature in the warmest part of

the freezer section.

If the temperatures in the appliance are

not within the range that the appliance

is able to display, bars will flash in the

temperature displays.

The temperature displays flash if

–

a different temperature is being set,

– the temperature in the appliance has

risen by several degrees, indicating

that the appliance is warming up too

much.

This loss of coldness is no cause for

concern in the following circumstances:

– when the door has been left open for

a while, e.g. for removing or storing a

large amount of food,

–

when fresh food is being frozen.

However, if the temperature in the

freezer section remains above -18 °C

for a long time, check that the frozen

food has not started to defrost. If it has

started thawing, check that the food is

safe to use and if it is, use it as quickly

as possible.

The correct temperature

19

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 67 68

Comments to this Manuals

No comments