Miele DA 3190 EXT Service Manual

Operating and installation instructionsCooker hoodsDA 3160DA 3180DA 3190DA 3160 EXTDA 3190 EXTTo avoid the risk of accidentsor damage to this applianc

Guide to the appliance10

a Exhaust socket ø 150 mmb Control panelc Grease filterd Pull-out deflector platee Hob lightingf Charcoal filter(extra accessory available to orderfor

The cooker hood works with. . . air extraction:The air is drawn in, cleaned by thegrease filter and then directed outside.If the on-site ventilation s

The cooker hood is operated by pullingout and pushing in the deflector plate.To switch the fan on^Pull out the deflector plate.The fan will begin to o

Automatic switch-off of the IntensivesettingYou can set the Intensive setting so thatit only runs for 10 minutes beforereverting automatically to leve

Before any cleaning or maintenancework is carried out, disconnect thecooker hood from the mains supply.Ensure that:– it is switched off at the wall so

ControlsThe controls may sufferdiscolouration or damage if soiling isleft on them for too long. Removesoiling straight away.Observe the General notes

Cleaning the grease filters by hand^Clean the filters with a soft nylonbrush in a mild solution of hot waterand a small amount of washing-upliquid.Do

Fitting and replacing thecharcoal filterIf the cooker hood is connected forrecirculation, a charcoal filter (optionalaccessory) must be inserted in ad

Changing a halogen lamp^Pull out the deflector plate, andremove the grease filter as describedearlier.^Switch off the fan and the lighting.Exercise ca

Caring for the environment. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3Warning and Safety instructions . . . .

DA 3160DA 3180*DA 3190*1) The front section of the wall housingunit must be fitted with a shelf to thedepth of the partition wall.2) The partition wal

Safety distance between hob andcooker hoodThe minimum safety distancesbetween the top of a cooker or hoband the bottom of the cooker hoodare as follow

Installation accessoriesInstallation22

a 2 hose clipsfor securing the vent ducting to theexhaust socket.b 1 reducing collarfor exhaust ducting C125 mm.c 1 non-return flapfor fitting into th

Installation24

Positioning the appliance inthe wall housing unitTo position the appliance correctly,cut the spacer strip to required depthT, and then attach it to th

^Screw the brackets onto the right andleft inside walls of the housing unit asshown. The back edge of thebrackets should align with the verticalline d

^When fitting a DA 3180 or a DA 3190into a 60 cm housing unit, unscrewthe brackets on the deflector platewhilst it is pulled out.^Lift the appliance u

^Secure the front of the appliance tothe floor of the housing unit frombelow using 4 screws (6 screws for90 cm wide cooker hood).To avoid damaging the

Aligning the deflector plate^ The position of the deflector platecan be brought forward by up to 50mm using the adjusting screws oneither side of the

Disposal of the packingmaterialThe transport and protective packinghas been selected from materials whichare environmentally friendly fordisposal, and

Set up for extraction mode^If the on-site ventilation system doesnot have a non-return flap, then thenon-return flap supplied with theappliance must b

^Fit the conversion kit as described inthe installation instructions suppliedwith the kit.^Make sure that the slats on theexhaust grille are directed

Important: To avoid the danger oftoxic fumes please observe theWarning and Safety instructions.This is especially crucial when usingthe cooker hood at

Important:If the exhaust ducting is to run throughrooms, ceiling space etc. where theremay be great variations in temperaturebetween the different are

All electrical work should beundertaken by a suitably qualifiedand competent person in strictaccordance with current nationaland local safety regulati

The Miele DSM 400 control module canbe used to combine the cooker hoodwith other components.It enables the following:Connection to a window contactswi

Connection to a light switchThe control module can be used toswitch on the cooker hood lighting via alight switch in the house.InstallationThe control

In the event of a fault which you cannotcorrect yourself, or if the appliance isunder guarantee, please contact:–Your Miele Dealer / Chartered Agentor

Connected load* ...280WFan motor* ...180WHob lighting ...2x50WVoltage ... AC230VFrequency ...

39

This appliance complies with allrelevant local and national safetyrequirements. Inappropriate usecan, however, lead to personal injuryand damage to pr

Alteration rights reserved / 4209M.-Nr. 07 287 200 / 02

~Before connecting the appliance tothe mains supply, make sure that thevoltage and frequency details given onthe data plate correspond with theon-site

~Do not connect the appliance to themains electricity supply by amulti-socket unit or an extension lead.These do not guarantee the requiredsafety of t

In order to ensure safe operation, andto prevent gases given off by theheating appliances from being drawnback into the room when the cookerhood and t

Correct use~Never use an open flame beneaththe cooker hood. To avoid the dangerof fire, do not flambé or grill over anopen flame.When switched on, the

~Follow the cooker or hobmanufacturer's instructions on the useof flammable materials over thecooker/hob when installing a wood orlaminate lights