Miele DA 6000 W Service Manual

Operating and installation instructionsCooker hoodDA 6000 WTo avoid the risk of accidents ordamage to the appliance it isessential to read these instr

~Safety regulations prohibit the fittingof a cooker hood over solid fuel stoves.~All ducting, pipework and fittingsmust be of non-flammable material.T

When the canopy is tilted forwards,cooking vapours are drawn into theopen glass slats, through the greasefilters inside the cooker hood and thenconduc

Guide to the appliance12dai2436

a Position when switched offb Position when switched onCanopy and slats openc Position for maintenancePosition for cleaning inside the cookerhood, for

Con|ctivityThis cooker hood is communicationenabled.Communication module XKM 2000 DAa, available as an optional extra,enables the operation of the coo

Hinged canopyThe cooker hood is operated byopening the hinged canopy.It opens by touching the On/Offsensor s or the Hob lighting sensor n.It closes by

Automatic switch-off of the IntensivesettingYou can set the Intensive setting so thatit always only runs for 10 minutesbefore reverting automatically

To switch the fan off s^Touch the On/Off sensor s to switchthe fan off.The canopy and the slats will close.If the On/Off sensor s is touched whilstthe

To switch the hob lighting off^Touch the Hob lighting sensor nbriefly. The canopy will remain open.^The light will also switch off if thecanopy is clo

Reading the grease filter operatinghours counterTo check the percentage of time setalready used^Press the On/Off sensor s to switchthe fan on.Wait unt

Caring for the environment...4Warning and Safety instructions ...5How the coo

^Touch the 1 sensor to select a shortertime and the 4 sensor to select alonger time, until the time requiredhas been set.^Touch the Grease filter sens

For your safetySafety switch-off for the canopyIf the canopy is prevented from closingby someone's hand or an objectblocking it, it will be relea

ProblemIf the canopy stops whilst it is beingopened or closed and you hear a longtone sounding 4 times, this means thatthe canopy's safety switch

A range of Miele branded cleaning andcare products are available to order viathe internet on www.miele-shop.com.HousingGeneralThe surfaces are suscept

Position for maintenanceThe housing can be opened to cleaninside the cooker hood, remove thegrease filters and to change the lamps.To open the housing

To close the housing^To close the housing again, raise thecanopy a up by pushing on thesecond glass slat from the top asshown, until it engages back i

Cleaning the grease filters by hand^Clean the filters with a soft nylonbrush in a mild solution of hot waterand a little washing-up liquid.Do not use

Changing a lamp,Exercise caution when changinghalogen lamps. They get very hotduring use, and remain hot for sometime after being switched off: danger

In the event of a fault which you cannotcorrect yourself, or if the appliance isunder guarantee, please contact:–your Miele Dealeror–the Miele Custome

Before installation it is important toread the information given on thefollowing pages as well as the"Warning and safety" instructions atthe

Appliance dimensions...30Safety distance between hob and cooker hood (S) ...31Connection f

Appliance dimensions3042040042°31016054550606615+20>120> 410588600A615+20915+20910280904892BBA588600615+20606892904915+20910150max.20 mmS > 3

Safety distance between hob andcooker hood (S)The safety distance between the topof a cooker or hob and the bottom ofthe cooker hood canopy mustmeasur

,Important: To avoid the dangerof toxic fumes, please observe theWarning and Safety instructions.This is especially crucial when usingthe cooker hood

Important:If the exhaust ducting is to run throughrooms, ceiling space etc. where theremay be great variations in temperaturebetween the different are

All electrical work should beundertaken by a suitably qualifiedand competent person in strictaccordance with current nationaland local safety regulati

The Miele DSM 400 control module canbe used to combine the cooker hoodwith other components.It enables the following:Connection to a window contactswi

Connection to a light switchThe control module can be used toswitch on the hob lighting on the cookerhood and also to dim it, depending onmodel, via a

Total connected load...504W– Fan motor ...290W– Canopy mechanism ...120+4W– Hob lighting ...4x20W– Feature lighting

38

39

Disposal of the packingmaterialThe transport and protective packinghas been selected from materials whichare environmentally friendly fordisposal, and

Alteration rights reserved / 4209M.-Nr. 07 665 740 / 01

This appliance complies with allrelevant local and national safetyrequirements. Inappropriate usecan, however, lead to personal injuryand damage to pr

~Before connecting the appliance tothe mains supply, make sure that theconnection details given on the dataplate correspond with the on-siteelectricit

~Do not connect the appliance to themains electricity supply by amulti-socket unit or an extension lead.These do not guarantee the requiredsafety of t

In order to ensure safe operation, andto prevent gases given off by theheating appliances from being drawnback into the room when the cookerhood and t

Correct use~Always switch the cooker hood onwhen a cooking zone is in use,otherwise condensation may collect inthe hood, which could cause corrosion.~