Miele DA 489-4 Service Manual

Operating and installation instructionsCooker hoodDA 489-4DA 489-4 EXTTo avoid the risk of accidentsor damage to this appliance,it is essential to rea

Guide to the appliance10

a Telescopic extension pieceb Recirculation grille(only for recirculation mode)c Towerd Canopye Control panelf Hob lightingg Grease filterh Charcoal f

The cooker hood works with. . . air extraction:The air is drawn in through the vapourplates, cleaned by the grease filter anddirected outside.If the o

Con|ctivityThis cooker hood is communicationenabled.Communication module XKM 2000 DAa, available as an optional extra,enables the operation of the coo

To switch the fan on^Press the On/Off control.The fan runs at power level "II". Theindicator lamp will come on.To select a power level^ Use

The indicator lamps for fan power levelsI and IV will flash if the automaticswitch-off for the Intensive setting is notactivated.^Press the + control

To switch the hob lighting onThe hob lighting can be switched onand off independently of the fan.^Briefly press the lighting control toswitch on the h

Filter operating hours counterThe number of hours the appliance hasbeen in operation is stored in memory.The operating hours counter tells youwhen the

Altering the grease filter operatinghours counterThe grease filter operating hourscounter is set at the factory for 30hours. This can be lengthened or

To activate and alter the charcoalfilter operating hours counter(in recirculation mode)The charcoal filter is needed forrecirculation mode.On delivery

Caring for the environment. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3Warning and Safety instructions . . . .

Resetting the charcoal filteroperating hours counterThe indicator lamp for the charcoal filtercontrol will light up after the cookerhood has operated

A range of Miele branded cleaning andconditioning agents are available toorder through your MieleDealer/Chartered Agent, the MieleSpare Parts Departme

ControlsThe controls may sufferdiscolouration or damage if soiling isleft on them for too long.Remove any soiling straight away.Observe the General no

^To remove the side vapour plates,hold on the side, pull out of theholder at the bottom (1), then slidetowards the middle and pulldownwards (2).^ See

When removing the filter for cleaning,also clean off any residues of oil or fatfrom the now accessible housing toprevent the risk of these catching fi

Glass surfaces^Glass surfaces can be cleaned usinga proprietary non-abrasive cleaningagent designed specifically for useon glass.–Avoid oven sprays.^

When fitting for the first time:^Activate the operating hours counter(see "Operation").Always replace the charcoal filter im-mediately if–th

Changing the halogen lamps^Before any cleaning or maintenancework, disconnect the cooker hoodfrom the mains supply.,Exercise caution when changinghalo

1) Extraction2) Recirculation3) Ventilation grille positioned at the topfor recirculation4) and 5):(5 is not required for recirculation modecooker hoo

Safety distance between hob andcooker hood (S)The safety distance between the topof a cooker or hob and the bottom ofthe cooker hood glass canopy must

Disposal of the packing materialThe transport and protective packinghas been selected from materials whichare environmentally friendly fordisposal, an

Assembly partsInstallation30

a 3 protective sheetsfor use when fitting the tower.b 1 exhaust connection for exhaustducting C 150 mm.c 1 reducing collarfor exhaust ducting C 125 mm

Before installation, it is important toread the information given on thefollowing pages as well as theAppliance dimensions and theWarning and Safety i

Important: To avoid the danger oftoxic fumes, please observe theWarning and Safety instructions.This is especially crucial when usingthe cooker hood a

–If the exhaust air is to be ducted intothe open air, the installation of atelescopic wall vent or roof vent(available as an optional accessory)is rec

Silencer(optional accessory)To achieve even further reductions innoise levels, a special silencer can befitted in the ducting system...with air extra

All electrical work should beundertaken by a suitably qualifiedand competent person in strictaccordance with national and localsafety regulations(BS 7

The Miele DSM 400 control module canbe used to combine the cooker hoodwith other components.It enables the following:Potential free connectionThis can

In the event of a fault which you cannotcorrect yourself, or if the appliance isunder guarantee, please contact:–your Miele Dealeror–the Miele Service

Total connected load* ...280W– Fan motor* ...200W– Hob lighting ...4x20WVoltage ... AC230VFrequency ...

This appliance complies with allrelevant local and national safetyrequirements. Inappropriate usecan, however, lead to personal injuryand damage to pr

Alteration rights reserved / 3011M.-Nr. 09 202 080 / 00

Technical safety~Before installation, check the cookerhood for visible signs of damage. Donot install and use a damagedappliance. It could be dangerou

~Do not connect the appliance to themains electricity supply by amulti-socket adapter or an extensionlead. These do not guarantee therequired safety o

In order to ensure safe operation, andto prevent gases given off by theheating appliances from being drawnback into the room when the cookerhood and t

Correct use~Never use an open flame beneaththe cooker hood. To avoid the dangerof fire, do not flambé or grill over anopen flame.When switched on, the

Correct installation~Refer to the cooker or hobmanufacturer's instructions as towhether a cooker hood may beoperated above the cooker/hob.~The mi