Miele M 326 EG Operations Instructions

Operating and InstallationInstructionsVentilation SystemDA 326-1 iDA 329-1 iTo prevent accidentsand machine damage,read these instructionsbeforeinstal

The hood offers two modes ofoperation:Air extractionThe air is drawn in and cleaned by thegrease filters and directed outside.The hood comes equipped

Turning the fan on^Pull the deflector plate out about 2"(5 cm).The hood will operate at power level "II".Selecting the power levelDepen

Turning the light onThe light for illuminating the cooktopcan be turned on or off independentlyof the fan.^Pull the deflector plate out 1.5"(3 cm

Before servicing or cleaning thehood, disconnect it from the powersupply by "tripping" the circuitbreaker or unplugging it.Make sure power i

Removing the filtersExternal filter^To remove the external filter pull thedeflector plate out slightly.^Turn the fan off.^ Holding the external filter

Inserting the filtersInternal filter^ Fit the filter into the appliance so thatit hooks into position at the back thenpush it up at the front and make

Inserting / replacing the activecharcoal filtersFor recirculation mode an activecharcoal filter must be used in additionto the grease filters. The cha

Changing the light bulbsIf the light does not work the bulb mayneed to be replaced or the starter couldbe defective.^Remove the external filter asdesc

In the event of a fault which you can notcorrect yourself please contact theMiele Technical Service DepartmentU [email protected] 1

Installation Instructions

2

Do not install this exhaust hood overcooktops burning solid fuel.When installing the hood, make surethat the following minimumdistance (S) between the

All electrical work should beperformed by a qualified electricianin strict accordance with nationaland local safety regulations.Installation, repairs

DA 326-1 i1) The slot for the active charcoal filtermust be accessible if the hood is beingused in recirculation mode.2) The rear panel of the cabine

Metric conversion tableMillimeters Inches31/8103/8159/16193/430 13/1640 19/1650 115/1670 23/475 385 33/888 31/2125 5150 6170 611/16175 67/8190 71/2245

Installation in cabinetryThe depth of the installation dependson what type of light shield is used andthe dimensions of surroundingcabinetry.Hood inst

Cabinet without rear panelIf the cabinet does not have a backpanel and there is no surroundingcabinetry a support bracket must beused to provide the u

Included partsInstallation26

a 2 hose clips for securing the ventducting to the vent connectionb 1 reducing collarfor exhaust ducting of 5" (125 mm)diameterc 1 non-return fla

1. Non-return flapAir extraction^Insert the non-return flap into the ventsocket so the flaps open upward.(This is not necessary if the ductingsystem i

3. Runners^ Cabinet width 60 cm:Install the runners on the left andright side of the cabinet with (4)3.5 x 16 mm screws on each side.If the side panel

IMPORTANT SAFETY INSTRUCTIONS. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4Guide to the hood . . . . . . . . . . . . . . . . . .

4. Hang the cabinet doorBefore installing the appliance, hangand align the cabinet door.5. Position the appliance in thecabinet^ Lift the venting hood

7. Installation of a lightshieldDFB lightshield (optional accessory)Follow the installation instructionssupplied with the DFB lightshield. Usethe scre

8. Align the depth of theappliance^Push the hood into position.9. Secure the appliance^ Tighten the middle screw of bothinstall brackets.10. Install s

11. Spacer strip for the rear ofthe appliance^Measure the gap "T" between the rearof the appliance and the wall.^ Use a knife to trim the su

12. Light cover^Pull the deflector plate slightly out.^Tilt the front of the external filterslightly down and out.^ Insert the two holders on to the s

13 a. Air extraction mode^Insert the panel supplied into theActive Charcoal Filter slot.^ Secure the ventilation ducting overthe vent socket of the ho

Connection for recirculation mode^ The exhaust grill b must be fitted inthe top of the unit.If the front of the hood is installed atceiling height the

Special installationinstructions279/16" (70 cm) width cabinet^ The measure "x" will be calculated asdescribed for a 235/8" (60 cm)

Danger of toxic fumes.Gas cooking appliances releasecarbon monoxide that can beharmful or fatal if inhaled. Theexhaust gases extracted by thehood shou

– If the exhaust is ducted into aninactive flue, the air must be expelledparallel to the flow direction of theflue.Never connect an exhaust hood toan

Read these Operating Instructions carefully before installing orusing the Ventilation System.This appliance is intended forresidential use only. Use t

Disposal of packing materialThe cardboard box and packingmaterials protect the appliance duringshipping. They have been designed tobe biodegradable an

41

42

43

M.-Nr. 05 864 020 / 05Alteration rights reserved / 1604This paper was bleached without the use of chlorine.

This equipment is not designed formaritime use or for use in mobileinstallations such as caravans oraircraft. However, under certainconditions it may

, WARNING - TO REDUCETHE RISK OF A RANGE TOPGREASE FIRE:Never leave surface unitsunattended at high settings.Boilovers cause smoking and greasyspillov

Installation, WARNINGTo reduce the risk of fire onlyuse metal ductwork.When installing the hood, follow therecommended minimum safetydistances between

Guide to the hood8

a Vent connectionb Active charcoal filter slotc Control paneld Pull-outdeflector platee DFB Facia Panel(must be ordered separately)f Internal grease f