Miele DA 400 EXT Service Manual

Operating and installation instructionsCooker hoodsDA 400, DA 400 EXTDA 403, DA 403 EXTTo avoid the risk of accidentsor damage to the applianceit is e

Description of the appliance10

a Cover plateb Telescopic towerc Canopyd Grease filterse Charcoal filter(special accessory for recirculationmode)f Recirculation grille(only for recir

The cooker hood works with. . . air extraction:The air is drawn in, cleaned by thegrease filters and directed outside.The cooker hood is fitted with a

Con|ctivityThis cooker hood is communicationenabled.Communication module XKM 2000 DAa, available as an optional extra,enables the operation of the coo

Switching on the fan^Press the On/Off touch control.The fan runs at power level "II".The indicator lamp will come on.If the cooker hood has

The indicator lamps for fan power levels"I" and "IV" will flash if the automaticswitch-off of the Intensive setting is notactivate

Switching the lighting onThe hob lighting can be switched onand off independently of the fan.^Briefly press the lighting touchcontrol to switch on the

Filter operating hours counterThe number of hours the appliance hasbeen in operation is stored in memory.The indicator lamp for the grease filtertouch

Filter operating hours counterYou can set the operating hourscounter to suit the type of cooking youdo.–Select a short time if you roast or frya lot.–

Setting and altering the charcoalfilter operating hours counter(with recirculation mode)The charcoal filter is needed forrecirculation mode.The cooker

Caring for the environment. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3Warning and Safety instructions . . . .

,Before carrying out any cleaningor maintenance work, disconnectthe cooker hood from the mainssupply. Ensure that:– it is switched off at the isolator

ControlsThe controls may sufferdiscolouration or damage if soiling isleft on them for too long. Removesoiling straight away.Observe the General notes

Cleaning the grease filters in thedishwasher^Place the filters as upright aspossible in the lower basket, with theshort sides upright, and wash on a65

Fitting and replacing thecharcoal filterIf the cooker hood is connected forrecirculation, a charcoal filter must beinserted in addition to the grease

Changing a halogen lamp^Before any cleaning or maintenancework, disconnect the cooker hoodfrom the mains supply. Ensure that–it is switched off at the

In the event of a fault which you cannotcorrect yourself, or if the appliance isunder guarantee, please contact:–Your Miele Dealer / Chartered Agentor

DA 400(Ceiling fixing viewed from above)DA 403(Ceiling fixing viewed from above)1) Alternative positions for feedingthrough the mains cable2) For ...E

Safety distance between hob andcooker hood (S)For safety reasons a minimum safetydistance must be maintainedbetween the top of the cooker/hoband the b

Assembly parts4 screws8x60mmwith4 washers and4 plugs S 10 to secure the cover plateto the ceilingThe screws and plugs are designedfor use in concrete

,All electrical work should beundertaken by a suitably qualifiedand competent person in strictaccordance with current nationaland local safety regulat

Disposal of the packingmaterialThe transport and protective packinghas been selected from materials whichare environmentally friendly fordisposal, and

The Miele DSM 400 control module canbe used to combine the cooker hoodwith other components.It enables the following:Connection to a window contactswi

Connection to a light switchThe control module can be used toswitch on the cooker hood lighting andalso to dim it (depending on model) viaa light swit

Important: To avoid the danger oftoxic fumes, please observe theWarning and Safety instructions.This is especially crucial when usingthe cooker hood a

Important!If the exhaust ducting is to run throughrooms, ceiling space etc. where theremay be great variations in temperaturebetween the different are

Total connected load * ...280WFan motor * ...200WHob lighting ...4x20WVoltage ...AC230VFrequency...

35

Alteration rights reserved / 4309M.-Nr. 07 260 930 / 02

This appliance complies with allrelevant local and national safetyrequirements. Inappropriate usecan, however, lead to personal injuryand damage to pr

Technical safety~Before installation, check the cookerhood for visible signs of damage.Under no circumstances should youuse a damaged appliance. A dam

~Do not connect the appliance to themains electricity supply by amulti-socket unit or an extension lead.These do not guarantee the requiredsafety of t

In order to ensure safe operation, andto prevent gases given off by theheating appliances from being drawnback into the room when the cookerhood and t

Correct use~Never use an open flame beneaththe cooker hood. To avoid the dangerof fire, do not flambé or grill over anopen flame.When switched on, the

~Safety regulations prohibit the fittingof a cooker hood over solid fuel stoves.~All ducting, pipework and fittingsmust be of non-flammable material.T