Miele KDN 9713 iD Installation Manual download pdf (Page 32)

. . . the frozen food is thawing

because the freezer section is too

warm.

^

Is the room temperature lower than

the ambient temperature for which

the appliance is designed?

If so, raise the temperature of the

room.

Operating in a room which is too cold

will cause the cooling system to switch

off for too long causing the freezer

section to become too warm.

. . . food has frozen together.

Use a blunt instrument, e.g. a spoon

handle or plastic scraper, to prise it

apart carefully.

. . . the alarm sounds and the alarm

indicator light is flashing.

The temperature has risen above the

setting on the temperature dial because

^

the door has been opened too

frequently, or large amounts of fresh

food have been put in at once for

freezing.

^

the temperature dial has been turned

to a higher setting and the appliance

has not yet had sufficient time to

reach the temperature set.

^

the ventilation gaps are blocked.

Once the problem has been resolved

the alarm indicator light will go out and

the alarm will stop.

. . . the Super freeze indicator light

and the temperature display are both

flashing at the same time.

There is a fault. Call the Service

Department.

. . . the Super freeze indicator light

does not light up, even though the

appliance is working.

The indicator light is defective. Call the

Service Department.

. . . the interior light in the

refrigerator section is not working.

Has the refrigerator door been left open

for too long? The lighting switches itself

off automatically after approx. 15

minutes.

If it also does not come on when the

door is opened briefly, but the

temperature display is working, then

the lamp is defective.

^ Disconnect the appliance from the

mains. Switch off at the wall and

withdraw the plug from the socket, or

disconnect the mains fuse or remove

the screw-out fuse in countries where

this is applicable.

^

Grasp the lamp cover at the top and

at the bottom (1), and pull it forwards

to remove (2).

Problem solving guide

32

1 ... 31 32 33 ... 44

Comments to this Manuals

No comments