Miele 26562151USA Manual

Operating and InstallationInstructionsCeramic CooktopKM 5621KM 5624KM 5627To prevent accidents andappliance damage,read these instructionsbeforeinstal

KM 5627acde Variable burnersb Standard burnerf Residual heat indicatorBurner dataBurner C Diameter Output in Watts atinch cm 208 V 240 VLeft front a 7

Clean the cooktop^Before using for the first time, cleanthe appliance with a damp cloth anddry with a soft cloth.Do not use liquid dish soap to cleant

One-zone burners use one heatingstrip; two-zone burners and grill zoneshave two heating strips. Depending onthe model, the heating strips may besepara

The burners are turned on when thecorresponding control knob is pressedin and rotated to the desired outputlevel.Control knobs for one-ring burners ca

Residual heat indicatorAfter turning on a burner, for examplethe left front, a specified temperature isreached, the associated residual heatindicator

–Use cookware with thick, flat, smoothbottoms. Slightly concave bottomswill also work adequately. Pans withconvex bottoms will not cook well.cold hot–

Each cooking zone is equipped with atemperature limiter. This featureautomatically turns off the heatingelement before the glass ceramicbecomes too ho

Do not use a steam cleaner to cleanthis appliance. Steam couldpenetrate electrical components andcause a short circuit. Pressurizedsteam could cause p

,Repairs should be carried out only by an authorized technician inaccordance with local and national safety regulations. Unauthorized repairscould cau

In the event of a fault which you cannoteasily fix yourself, please contact theMiele Technical Service Department atthe address on the back of this bo

IMPORTANT SAFETY INSTRUCTIONS...3Description of the cooktop ...8KM 5621...

20

Installation InstructionsIMPORTANT: SAVE FOR THE LOCAL ELECTRICAL INSPECTOR'S USEInformation is subject to change. Please refer to our website to

Note to the installer:Please leave this instruction bookwith the consumer for the localelectrical inspector’s use.The minimum distances given inthese

Safety distance from dividerInstallation of a divider under thecooktop is not required.If a divider is fitted under the cooktop,the distance between t

Safety distances to the sidesof the applianceThe appliance should only be installedas shown in the illustrations, whilemaintaining the required safety

Safety distance from the wall coveringIf a wall covering is installed, a minimum safety distance must be maintainedbetween the countertop cut-out and

Frame/Facet CooktopsSealingThe appliance must not be permanentlysealed into the countertop wheninstalled. The sealing strip under theedge of the appli

KM 5621a Spring clipsb Frontc Installation heightd Power cord,L=5611/16" (1440 mm)e Rating labelInstallation dimensions27(75 mm)15/16"2201/1

KM 5624a Spring clipsb Frontc Installation heightd Power cord,L=5611/16" (1440 mm)e Rating labelInstallation dimensions28

KM 5627a Spring clipsb Frontc Installation heightd Power cord,L=5611/16" (1440 mm)e Rating labelInstallation dimensions29

WARNING- When using yourappliance follow basicprecautions, including thefollowing:Read all instructions beforeinstallation or use to preventinjury and

The exact positions of the springclamps and the support bars (forbeveled cooktops only) are shown inthe "Installation dimensions" of eachuni

Granite countertopStrong double-sided adhesive tapeand silicon are required forinstallation (not included).^Using adhesive tape c attach thespring cli

Insert the cooktop^Feed the power cord down throughthe cut-out.^Place the cooktop lightly on thespring clips.^With a hand on each side of theappliance

,CAUTION: Before installation orservicing, disconnect the powersupply by either removing the fuse,shutting off the main power ormanually "trippin

Disposal of packing materialsThe cardboard box and packingmaterials are biodegradable andrecyclable. Please recycle.Ensure that any plastic wrappings,

35

Alteration rights reserved / 1811INFORMATION IS SUBJECT TO CHANGE. PLEASE REFER TO OUR WEBSITE TO OBTAIN THE MOSTCURRENT PRODUCT SPECIFICATIONS, TECHN

Technical safety~Installation, repair and maintenancework should be performed by a Mieleauthorized service technician. Work byunqualified persons coul

Safety~DO NOT TOUCH THE COOKINGAREA OR THE VICINITY AROUND THECOOKING AREA - During operation,the cooking area and its surroundingswill get hot and ca

~Make certain that the power cords ofsmall appliances do not come incontact with the appliance. Theinsulation of the cable could becomedamaged. Danger

~Any spills should be removed asquickly as possible to prevent themfrom burning on and becoming difficultto remove.~Aluminum cookware or cookwarewith

KM 5621ac Variable burnerbd Standard burnere Residual heat indicatorBurner dataBurner C Diameter Output in Watts at208/240 Vinch cmLeft front a 43/4&q

KM 5624ac Variable burnerbd Standard burnere Residual heat indicatorBurner dataBurner C Diameter Output in Watts at208/240Vinch cmLeft front a 71/16&q