Miele Paragon sensor Operations Instructions download pdf (Page 37)

Rear view

a Protruding lid for holding when

moving the appliance (see arrows)

b Air inlet vent for cooling the

condenser unit

c Mains connection cable

d External drainage of the condensed

water

e Accessories for connection to a sink

drain outlet

Installation site

,

Make sure the dryer door can be

opened without hindrance after

installation.

Transporting the tumble dryer to its

installation site

When moving the appliance, you can

hold it by the lid where it protrudes to

the rear of the dryer. To manoeuvre the

dryer out of its packing case to its

installation site you will also need to

hold it by the front feet. Do not lift the

appliance by the drum door.

Building under a continous worktop /

in a kitchen run

,

A building-under kit* with a

coverplate to replace the appliance

lid is required. It must be fitted by a

suitably qualified person to ensure

electrical safety.

N.B. If you wish to push your appliance

under a worktop and there is space to

do this without removing the lid the

building under kit is not necessary.

Otherwise the building under kit is

essential.

– The building-under kit is supplied

with its own installation instructions.

– N.B. When built under drying times

may be longer.

– The electrical socket must be

located in an accessible position

near the tumble dryer.

With niche heights of:

–

830-840 mm, longer screw feet* are

required.

–

870-885 / 915-930 mm, one or two

raising kits* are required.

* accessory available to order.

Replacing the lid

If the lid has been removed in order to

fit a coverplate, ensure that, if the lid is

ever replaced, it fits securely into the

rear holders. Otherwise, it is not

properly secure for transport.

Installation

37

1 ... 36 37 38 ... 52

Comments to this Manuals

No comments