Miele T 4809 Ci Operations Instructions download pdf (Page 42)

For right hand hinging only:

–

front panel shown decor side face

down, upper edge at the bottom:

if width (b) increases, measurement a

must also be increased

b = 592 mm N a = 21.5 mm

b = 593 mm N a = 22.0 mm

b = 594 mm N a = 22.5 mm

b = 595 mm N a = 23.0 mm

b = 596 mm N a = 23.5 mm

H = height of adjacent furniture unit

doors.

C Drill the two hinge holes (C 35

mm/15.5 mm deep) in the back of

the front panel.

D Next, drill the four smaller holes

(C 7 mm/10 mm deep) in the back of

the front panel.

E Shorten the front panel from the

bottom to height H.

Preparing the fixing points

F Hold the pre-drilled front panel in the

correct position in front of the

machine door.

G Mark the fixing points on the back of

the front panel through the holes in

the machine door plate (see arrows

in the illustration).

H Remove the front panel.

I Now drill holes (C 2.5 mm/10 mm

deep) in the back of the front panel.

Installation

42

1 ... 41 42 43 ... 60

Comments to this Manuals

No comments