Miele KM 5773 User Manual download pdf (Page 49)

Preparing the worktop

^

Make the worktop cut-out following

the dimensions applicable.

Remember to maintain a minimum

safety distance of 50 mm from the

back wall, as well as from any tall unit

or side wall to the right or left of the

hob.

See "Safety instructions for

installation".

^

Seal the cut surfaces with a suitable

heat-resistant sealant to avoid

swelling caused by moisture.

If, during installation, you find that

the seals on the corners of the frame

are not flush with the worktop, the

corner radius ß R4, can be carefully

scribed to suit.

These hobs have a seal underneath

them to keep the hob securely in

position. Clamps are not required.

Any gap between the frame and

worktop will reduce with time.

Installing the hob

^

Feed the hob connection cable down

through the cut-out.

^

Place the hob centrally in the cut-out.

When doing this make sure that the

seal under the hob sits flush with the

worktop on all sides. This is important

to ensure an effective seal all round.

Do not use sealant.

^

Connect the hob to the mains.

^

Check that the hob works.

Installation

49

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 55 56

Comments to this Manuals

No comments