Miele KM 6351 User Manual download pdf (Page 70)

Installing the hob

Preparing the worktop

^

Make the worktop cut-out according

to the dimensions given in the

building-in diagram. Remember to

maintain the minimum safety

distances (see "Safety instructions

for installation").

^

Seal the cut surfaces of

wood/laminated worktops with a

suitable heat-resistant sealant to

avoid swelling caused by moisture.

Make sure that the sealant does not

come into contact with the top of the

worktop.

No spring clamps are needed to

install the hob. The sealing strip

underneath the hob positions it

securely in the cut-out.

Any gap between the frame and

worktop will reduce with time.

Connecting the mains cable to the

appliance

The mains cable must only be

connected to the appliance by a

qualified and competent electrician

in strict accordance with current

local and national safety regulations

(BS 7671 in the UK).

^

Follow the instructions in the wiring

diagram (see "Electrical connection -

Wiring diagram").

Installing the hob

^

Feed the mains connection cable

down through the cut-out.

^

Place the hob centrally in the cut-out.

When doing this, make sure that the

seal under the hob sits flush with the

worktop on all sides. This is important

to ensure an effective seal all round.

Do not use sealant (e.g. silicone).

If the corners of the frame are not

flush with the worktop surface, the

corner radius (ß R4) can be carefully

scribed to fit.

^ Connect the hob to the mains.

^ Check that the hob works.

Hob with frame or bevelled edge

70

1 2 ... 65 66 67 68 69 70 71 72 73 74 75 ... 83 84

Comments to this Manuals

No comments