Miele DA5980W User Manual download pdf (Page 32)

,WARNING

TO REDUCE THE RISK OF

FIRE, ELECTRIC SHOCK, OR

INJURY TO PERSONS,

OBSERVE THE FOLLOWING:

All electrical work should be

performed by a qualified electrician

in strict accordance with national

regulations (for USA: ANSI-NFPA 70)

and local safety regulations.

Installation, repairs and other work

by unqualified persons could be

dangerous.

Ensure that power to the appliance

is OFF while installation or repair

work is performed.

^ Verify that the voltage, load and

circuit rating information found on the

data plate (located behind the

grease filter), match the household

electrical supply before installing the

hood.

^

Use only with ventilation hood

cord-connection kits that have been

investigated and found acceptable

for use with this model hood.

If there is any question concerning the

electrical connection of this appliance

to your power supply, please consult a

licensed electrician or contact Miele’s

Technical Service Department.

,WARNING:

THIS APPLIANCE MUST BE

GROUNDED

Grounding Instructions

(USA and Mexico only)

This appliance must be grounded. In

the event of an electrical short circuit,

grounding reduces the risk of electric

shock by providing a path of least

resistance. This appliance is equipped

with a cord having a grounding wire

with a grounding plug. The plug must

be plugged into an outlet that is

properly installed and grounded.

WARNING - Improper grounding can

result in a risk of electric shock.

If there is any doubt, have the electrical

system of the house checked by a

qualified electrician.

Do not use an extension cord. If the

power supply cord is too short, have a

qualified electrician install an outlet

near the appliance.

Important (USA and Mexico only)

The hood comes equipped witha4ft

(1.2 m) power cord with a NEMA 5-15

molded plug for connection to a

120 VAC, 60 Hz, 15 A power outlet.

Important (Canada only)

To increase security before the

machine is installed, it is

recommended to install a protective

switch (30 mA).

Important (Canada only)

The hood must be hard wired

accordingly:

Black/Red wire: connect to L1 (live)

White wire: connect to N (neutral)

Green wire: connect to GND (ground)

Electrical connection

32

1 ... 31 32 33 34 35 36

Comments to this Manuals

No comments