Miele Dishwasher G 658 SCVI User Manual download pdf (Page 15)

Programming the water softener

Your water hardness level must be

programmed into the dishwasher using

the buttons on the control panel.

The programming can be cancelled

and restarted at any time by turning

the dishwasher off using the "Off"

button, (16).

^ Open the door.

^ Turn off the dishwasher.

^ Press and hold the a and c buttons.

At the same time turn on the

dishwasher with the "On" (15) button.

^ Release all buttons.

The "Salt" and b indicators will flash.

If this is not the case, the above steps

must be repeated.

^

Press the b button.

The b indicator goes out and the "Salt"

indicator will flash.

If your water hardness is greater

than 12 gr/gal (220 ppm) proceed to

the next page.

1 - 12 gr/gal:

An indicator corresponding to a preset

water hardness will light (see Table 1).

Table 1:

gr/gal* ppm Button

1 - 4** 20 - 70 a

5 - 6 90 - 110 b

7 130 c

8 - 10 140 - 180 d

11 - 12 200 - 220 e

* US gallons

** Factory preset

If this value corresponds with the water

hardness in your area:

^ Turn off the dishwasher.

If you need to program a different water

hardness:

^

Press the button, which corresponds

with your water hardness (see

Table 1).

The "Salt" and b indicators will flash.

^

Press the f button twice.

The "Salt" and f indicators will flash.

The new water hardness is set.

^

Turn off the dishwasher.

Before using for the first time

15

1 ... 14 15 16 ... 56

Comments to this Manuals

No comments