Miele HG01 User Manual download pdf (Page 16)

Install the bracket on the rear of the

custom door panel

Make sure the dishwasher is level.

Measure the distance X between the

round hole in the machine outer door

panel (shown in inset) and the lower

edge of the adjoining cabinet door.

^ Place the door panel on a flat sur-

face, good side face down, being

careful not to scratch the surface.

Make certain that the bottom of the

panel is towards you.

Using a pencil, lightly draw a vertical

centerline on the panel (See the illus

tration on the next page).

Draw a horizontal line X inches up

from the bottom edge of the panel.

For two piece panels:

If your two piece panel is joined to

gether using hardware that is not flush

with the rear of the panel, this hardware

must be removed. The mounting

bracket supplied with the machine can

be used to secure both pieces to the

dishwasher.

When mounting the two pieces,

make sure that the desired finished

panel height is maintained.

Installation

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 35 36

No comments

Miele HG01 User Manual Page 16