Miele T 510 Operations Instructions download pdf (Page 62)

,

Danger of injury!

All electrical work should be

undertaken by a suitably qualified

and competent person.

Installation, repairs and other work

by unqualified persons could be

dangerous. Miele cannot be held

liable for unauthorised work.

Ensure power is not supplied to the

appliance until after installation or

repair work has been carried out.

Connection of this appliance should

comply with national and local safety

regulations.

Connection to a switched socket is

recommended as this provides easier

access in the case of a service call.

If the switch is not accessible after

installation or the appliance is hard-

wired (depending on country), an

additional means of disconnection must

be provided for all poles.

When switched off there must be an all-

pole contact gap of 3 mm in the isolator

switch (including switch, fuses and

relays according to EN 60335).

Connection data

The required connection data can be

found on the data plate located on the

oven frame visible when the door is

open.

Please ensure this information matches

the household mains supply.

When contacting Miele, please quote

the following:

–

model number,

–

serial number,

–

connection data (voltage/frequency/

maximum rated load).

When replacing the connection

cable supplied with another cable,

or changing the connection, only

cable type H 05 VV-F with a suitable

cross-sectional area (CSA) may be

used (available from Miele).

Electrical connection

62

1 ... 61 62 63 ... 72

Comments to this Manuals

No comments