Miele H 6090 B User Manual download pdf (Page 47)

Stubborn soiling on the

FlexiClip runners

Never attempt to clean FlexiClip

telescopic runners in a dishwasher.

This would remove the special

grease which is essential for their

smooth functioning.

For stubborn surface soiling or if the

bearings become sticky with spilled

fruit juices proceed as follows:

^

Soak the FlexiClip runners for approx.

10 minutes in a solution of hot water

and washing-up liquid. If necessary

use the back of a washing-up

sponge to remove the soiling. The

bearings can be carefully cleaned

with a soft brush.

Cleaning may cause some

discolouration or fading in places,

however this will not affect the

functioning of the runners in any way.

Cleaning the catalytic back

panel

Soiling from oil and fat is burnt off

catalytic enamel when very high

temperatures are used in the oven.

The higher the temperature, the more

effective the process.

Exposure to scouring agents,

abrasive brushes or sponges and

oven sprays can cause catalytic

enamel to lose its self-cleaning

properties.

Catalytic enamelled panels should

therefore be taken out of the oven

before using oven spray in it.

Removing spice, sugar and similar

deposits

^ Remove the back panel (see relevant

section later on in this chapter).

^ Clean the back panel by hand with a

solution of hot water and washing-up

liquid applied with a soft brush.

^

Rinse thoroughly and then leave to

dry before fitting back in the oven.

Cleaning and care

47

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 67 68

Comments to this Manuals

No comments