Miele DGC 5061 Operations Instructions download pdf (Page 64)

Problem Possible cause Remedy

Demo mode has been

set and the appliance

does not heat up.

Select and confirm

"Settings - Showroom

prog. - .Off."

The fan can still be

heard after the

appliance has been

switched off.

The appliance is fitted

with a fan which removes

steam from the oven. The

fan continues to run even

after the appliance has

been switched off.

This is not a fault.

The fan switches off

automatically after a

certain period of time.

The water container has

become harder to put

into the appliance and

take out again.

The coupling seal on the

water container is stiff.

Lightly lubricate the

coupling seal with

silicone grease, as

described in "Cleaning

and care - Coupling seal".

The heating-up phase

lasts an unusually long

time.

A layer of limescale has

built up in the bottom of

the water container as the

water hardness level has

not been set correctly.

Set the appropriate water

hardness level for the

mains water supply (see

"Settings - Water

hardness", and descale

the appliance as

described in "Descale".

If the correct water

hardness level was

already set, or if the

problem recurs, call the

Service department.

After moving house the

appliance no longer

switches from the

heating-up phase to the

cooking phase.

The boiling temperature

of the water has changed

as the altitude of the new

location for the appliance

differs from the old one

by at least 300 m.

To adjust the boiling

temperature, descale the

appliance (see "Cleaning

and care - Descale").

Problem solving guide

64

1 2 ... 59 60 61 62 63 64 65 66 67 68 69 ... 75 76

Comments to this Manuals

No comments