Miele T 8826 WP Operations Instructions download pdf (Page 44)

Before moving the tumble dryer

again (e.g. when moving house)

After each use a small quantity of

condensed water will collect in the area

around the pump. This water can run

out if the tumble dryer is tipped up

when it is being moved. It is a good

idea to run the Cool air programme for

approximately 1 minute before moving

it. Any remaining condensed water will

then be fed into the condensed water

container or out through the drain hose.

Installation site

,

Make sure the dryer door can be

opened without hindrance after

installation.

,

The cool air intake panel at the

front of the dryer must not be

blocked or covered, e.g. by a

laundry basket, as this would cause

a fault.

Building under a continuous worktop/

in a row of kitchen units

,

It is very important to avoid a

build-up of heat.

The warm air which is expelled from

the rear of the dryer must be able to

dissipate.

Warm air which cannot dissipate

could cause a fault.

A build-up of heat can be avoided by:

–

Adjusting the screw feet so that there

is a gap of at least 20 mm between

the floor and the bottom of the dryer.

–

Creating a gap for the dryer in the

kitchen furniture plinth facing.

–

Creating ventilation gaps in the

kitchen unit.

N.B. When built under, drying times

may be longer.

,

The dryer should not be installed

next to a refrigeration appliance. The

warm air expelled from the rear of

the dryer would increase the

temperature around the refrigeration

appliance's heat exchanger causing

the compressor to run continuously.

If it is not possible to install the dryer

anywhere else, then the refrigeration

appliance must be sealed off from

the dryer.

,

A building-under kit (Miele

accessory, available to order) with a

coverplate to replace the

appliance´s lid is required. It must

be fitted by a suitably qualified

person to ensure electrical safety.

N.B. If you wish to push the tumble

dryer under a worktop and there is

space to do this without removing

the lid the building-under kit is not

necessary. Otherwise the

building-under kit is essential.

Installation

44

1 ... 43 44 45 ... 64

Comments to this Manuals

No comments