Miele S8 UniQ User Manual download pdf (Page 40)

You can replace the standard Active

HEPA c filter with either one of the

following exhaust filters:

a Air Clean

b Active Air Clean.

When replacing an Active HEPA filter

with an Air Clean filter, please note

(dia. 32)

If you wish to replace the Active HEPA

filter c with an Air Clean filter a, then it is

essential that you also fit the filter grille

(See "Optional accessories").

The exhaust filter indicator light (dia.

28) is designed to come on when the

Active HEPA or Active Air Clean filter

needs to be changed. The filter

change indicator light is irrelevant if

an Air Clean filter is being used, as

long as it is replaced every time a

new packet of Miele dustbags is

started. The indicator light will go out

when the reset button is pressed.

Inserting batteries into the LED

handle (dia.9+10)

You will need three 1.5 V (AAA) batteries.

a Loosen the screws on the cover.

b Press down on both sides of the

cover to remove.

c Take out the battery holder and

change the three batteries, making

sure they are the right way round.

d Replace the battery holder. in the

direction of the arrows on the holder

and battery compartment, so that

both line up.

e Replace the cover and tighten the

screws.

When to change the thread lifters

The thread lifters on the suction inlet of

the floorhead can be replaced.

Check them from time to time and re

-

place them if the pile has worn down.

How to replace the thread lifters

AllTeQ floorhead (dia. 33)

^

Use a suitable screwdriver to remove

the thread lifters from the slots. There

are two grooves to help you.

^

Fit new thread lifters.

AirTeQ floorhead (dia. 34)

^ Use a suitable screwdriver to remove

the thread lifters from the slots.

^ Fit new thread lifters.

Cleaning the roller on the AllTeQ

floorhead (dia. 35)

(Not necessary for the AirTeQ floorhead)

a Release the bearing (with bayonet

fitting) using a coin.

b Press the bearing out, and remove it.

c Take out the roller.

^

Remove any threads and hair, repla

-

ce the roller and refit the bearing.

Replacement parts are available from

your Miele retailer or from Miele (see

back cover for contact details).

Cleaning and care

,

Always disconnect the vacuum

cleaner from the electrical supply

before cleaning it. Switch off at the

wall socket and unplug it.

en

40

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 111 112

Comments to this Manuals

No comments