Miele G 7827 User Manual download pdf (Page 43)

Requirements

(refer to the Installation Diagram for

more information)

1. Cold water connection

One

1

/

2

" (13 mm) cold water supply line

with a standard

3

/

4

" (19 mm) male hose

thread faucet is needed. The cold water

supply hose is marked with blue tape.

2. Hot water connection

One

1

/

2

" (13 mm) hot water supply line

with a standard

3

/

4

" male hose thread

faucet is needed. The water

temperature must not exceed 158°F /

70°C (recommended: 140°F / 60°C).

The hot water supply hose is marked

with red tape.

If no hot water line is available, the red

marked hose must be connected to the

cold water line.

3. DI water connection

One

1

/

2

" (13 mm) deionized water

supply line with a standard

3

/

4

" (19 mm)

male hose thread faucet is needed. The

machine cannot be operated

conventionally with a flow pressure of

less than 10 psi. In this case the

installation of an optional DI pump is

required. The DI water supply hose is

marked with green tape.

If the water pressure is below 29 psi,

the intake time will increase.

,

If the machine will not be

connected to DI water, the cleaning

and disinfection programs must be

changed by Miele Technical Service.

The intake hose stays at the rear of

the machine.

DI water connection (pressureless)

1.25 - 9 psi (optional)

For connection to 1.25 - 9 psi water

pressure the machine must be

converted if it was not ordered from the

factory as a special model. A feed

pump must be installed by Miele's

Technical Service Dept.

The discharge nipple of the DI water

container (pressureless) must be at

least at the same height as the

machine's upper edge (see the

"Installation Manual").

Plumbing

43

1 ... 42 43 44 45 46 47 48

Comments to this Manuals

No comments