Miele G 7827 User Manual download pdf (Page 6)

Take care when handling liquids

such as detergents, neutralizing

agents, wetting agents and rinse aids.

These may contain irritant or corrosive

ingredients, acids or alkalis. Never use

any organic solvents, as the danger of

explosion exists. Wear protective

gloves and goggles. The

manufacturer’s safety conditions must

be observed at all times.

The water in the machine must not

be used as drinking water.

Be careful when sorting items with

sharp pointed ends. Position them

in the machine so that you do not hurt

yourself or create a danger for others.

When using this machine regard

the high temperatures and be

especially careful not to scald or burn

yourself. When opening the door

bypassing the electrical lock, a danger

of burning, scalding and corrosion

exist. Let mobile units, inserts and

cleaned items cool before touching

them. Any water which may remain in

containers will be very hot and must be

emptied into the wash cabinet.

After drying with the TA drying unit

open the door to allow the items

and inserts to cool.

Do not touch the heating elements

(under the wide area filter) during

or directly after the end of a program,

you could burn yourself. They remain

hot for some time after the program

end.

If the boiler has been programmed

to "BOILER READY", be particularly

careful of hot water and steam when

opening the door. Danger of burning or

scalding. The water inlet pipe to the

wash cabinet is located, as viewed

from the unclean side, underneath the

basket runner on the left hand side.

Steam heating is permissible up to

a pressure of 145 psi. This

corresponds to a water steam

temperature of 354°F (179 °C).

Never clean the machine near or

with a water or high pressure hose.

Before servicing, disconnect the

power supply by either removing

the fuse, unplugging the unit or

manually "tripping" the circuit breaker.

,

Mount on non-combustible floors

only!

IMPORTANT SAFETY INSTRUCTIONS

6

1 2 3 4 5 6 7 ... 48

Comments to this Manuals

No comments