Miele HG01 User Manual download pdf (Page 26)

Venting the drainage system

If the dishwasher drain hose is con

-

nected to a floor drain or to a drain

pipe that is less than 8" (20 cm)

above the floor, the drain must be

vented. Otherwise the water inside the

dishwasher may siphon out during the

wash program.

To vent the drain:

^

Open the dishwasher door and re

-

move the lower basket.

^

Cut off the vent cap located at the

right rear of the triple filter system, as

illustrated.

Additional note

Since all Miele dishwashers are

equipped with an odor trap and non-re

-

turn valve, the drain hose can be con

-

nected directly to the drain pipe as il

-

lustrated.

If plumbing codes require an external

air gap on the discharge side of the

dishwasher, the following requirements

must be met:

–

No part of the drain hose should be

higher than 39" (1 m).

–

If installed horizontally, the drain

hose can be up to 12 ft. (3.5 m) long.

If the drain hose is angled upwards

in any way, it cannot be longer than

5 ft. (1.5 m).

– The drain connection should be

made as close as possible to the

dishwasher.

– The internal diameter (

7

/

8

" or 22 mm)

of the drain hose should not be re-

duced at any point.

Installation

26

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 35 36

Comments to this Manuals

No comments