Miele F 9052 i User Manual download pdf (Page 7)

Technical safety

Before setting up the appliance,

check it for any externally visible

damage.

Do not install and use a damaged

appliance.

This appliance contains the coolant

Isobutane (R600a), a natural gas

which is environmentally friendly.

Although it is flammable, it does not

damage the ozone layer and does not

increase the greenhouse effect. The

use of this environmentally friendly

coolant has, however, led to a slight

increase in the noise level of the

appliance. In addition to the noise of

the compressor, you might be able to

hear the coolant flowing around the

system. This is unavoidable, but does

not have any adverse effect on the

performance of the appliance.

Care must be taken during the

transportation and setting up of the

appliance that no parts of the cooling

system are damaged. Leaking coolant

can damage the eyes.

In the event of any damage:

- avoid open fires and anything which

creates a spark,

- disconnect from the mains,

- air the room in which the appliance is

located for several minutes and

- contact the Service Department for

advice.

The more coolant there is in an

appliance, the larger the room it

should be installed in. In the event of a

leakage, if the appliance is in a small

room, there is the danger of

combustible gases building up.

For every 8 g of coolant at least 1 m

3

of

room space is required. The amount of

coolant in the appliance is stated on the

data plate inside the appliance.

Before connecting the appliance to

the mains supply, make sure that

the rating on the data plate

corresponds to the voltage and

frequency of the household supply.

This data must correspond in order to

avoid the risk of damage to the

appliance. Consult a qualified

electrician if in any doubt.

The electrical safety of this

appliance can only be guaranteed

when continuity is complete between it

and an effective earthing system which

complies with current local and national

safety regulations. It is most important

that this basic safety requirement is

present and tested regularly, and where

there is any doubt, the household

wiring system should be inspected by a

qualified electrician.

The manufacturer cannot be held liable

for damage or injury caused by the lack

of or inadequacy of an effective

earthing system (e.g. electric shock).

If the connection cable is faulty it

must only be replaced by a Miele

approved service technician to protect

the user from danger.

Warning and Safety instructions

7

1 2 3 4 5 6 7 8 9 10 11 12 ... 47 48

Comments to this Manuals

No comments