Miele DA 249-4 Service Manual

Operating and Installation instructionsRangehoodDA 249-4,DA 249-4 EXT,DA 249-4 Alu,DA 249-4 Alu EXTTo avoid the risk of accidentsor damage to the appl

~Safety regulations prohibit the fittingof a rangehood over solid fuel stoves.~All ducting, pipework and fittingsmust be of non-flammable material.The

The rangehood works with. . . air extraction:The air is drawn in and cleaned by thestainless steel outer filter and thegrease filter, and then directe

Guide to the appliance12

a Telescopic extension pieceb Recirculation grille(optional accessory for recirculationmode only)c Towerd Canopye Cooktop lightingf Charcoal filter(sp

Con|ctivityThis rangehood is communicationenabled.Communication module XKM 2000 DAa, available as an optional extra,enables the operation of the range

To switch the fan on^Press the On/Off control.The fan will come on at power level "II".The indicator lamp will come on.To select a power lev

The indicator lamps for fan power levelsI and IV will flash if the automaticswitch-off for the Intensive setting is notactivated.^Press the + control

To switch the cooktop lightingonThe cooktop lighting can be switchedon and off independently of the fan.^Briefly press the lighting control toswitch o

Reading the filter operating hourscounterTo check the percentage of time setalready used:^Press the On/Off control to switch thefan on.^ Press and hol

The – / + indicator lamps show the timewhich has been set:1st lamp from the left = 20 hours2nd lamp from the left = 30 hours3rd lamp from the left = 4

Caring for the environment...4Warning and Safety instructions ...5Modes of op

^Use the – / + controls to select thedesired time.^Confirm the selection by pressing thecharcoal filter control.All the indicator lamps will go out.If

,Before any cleaning ormaintenance work is carried out,disconnect the rangehood from themains supply. Ensure that:– it is switched off at the wallsock

Important for appliances withstainless steel housing(This infomation does not apply to thecontrols).Stainless steel surfaces can be cleanedusing the O

To remove the stainless steel outerfilter^ To remove the outer filter, pull downon the quick-release catches. Whendoing this, hold the filter securely

^After cleaning, leave the filters to dryfor a while on an absorbent surfacebefore putting them back in place.^When removing the filters forcleaning,

Fitting and replacing thecharcoal filterIf the rangehood is connected forrecirculation, a charcoal filter must beinserted in addition to the grease fi

Always replace the filter immediately ifthe lamp for the charcoal filter touchcontrol comes on, or if it is no longereffective in absorbing kitchen od

Changing a halogen lamp^Before any cleaning or maintenancework, disconnect the rangehood fromthe mains supply. Ensure that:–it is switched off at the

The diagram is not drawn to scale.1) Extraction2) Recirculation3) Ventilation grille positioned at the topfor recirculation4) and 5):(5 is not require

Safety distances between cooktopand rangehood (S)The minimum safety distancesbetween the top of a cooktop andthe bottom of the rangehood areas follows

Operation with control module DSM 400...37Potential free connection ...37Connection t

Assembly partsInstallation30

a 2 protective sheetsfor use when fitting the tower.b 1 exhaust connection for exhaustducting C 150 mm.c 1 reducing collarfor exhaust ducting C 125 mm

Before installation, it is important toread the information given on thefollowing pages as well as the"Appliance dimensions" and the"Wa

Important: To avoid the danger oftoxic fumes, please observe theWarning and Safety instructions.This is especially crucial when usingthe rangehood at

–If the exhaust air is to be ducted intothe open air, the installation of atelescopic wall vent or roof vent isrecommended.–If the exhaust air is to b

Silencer (DASD 150)(optional extra)To achieve even further reductions innoise levels, a special silencer can befitted in the ducting system... . . Wi

All electrical work should beundertaken by a suitably qualifiedand competent person in strictaccordance with current nationaland local safety regulati

The Miele DSM 400 can be used tocombine the rangehood with othercomponents.It enables the following:Potential free connectionThis is used for controll

In the event of a fault which you cannotcorrect yourself, please contact:–MieleYou will find the telephone numberand address of Miele on the backcover

Total rated load* ...240W– Fan motor* ...200W– Cooktop lighting ...2x20WHalogen lampsOsram type 44890 WFL, 20 WVoltage .

Disposal of the packingmaterialThe transport and protective packinghas been selected from materials whichare environmentally friendly for disposaland

Alteration rights reserved / 3313M.-Nr. 09 729 510 / 00

This appliance complies with allrelevant local and national safetyrequirements. Inappropriate usecan, however, lead to personalinjury and damage to pr

Technical safety~Before installation, check therangehood for visible signs of damage.Under no circumstances should youuse a damaged appliance. A damag

~Do not connect the appliance to themains electricity supply by amulti-socket unit or an extension lead.These do not guarantee the requiredsafety of t

In order to ensure safe operation, andto prevent gases given off by theheating appliances from being drawnback into the room when the rangehoodand the

Correct use~Never use an open flame beneaththe rangehood. To avoid the danger offire, do not flambé or grill over an openflame.When switched on, the r