Miele G880 Operations Instructions download pdf (Page 65)

Venting the drainage system

Only if the dishwasher drain hose is

connected to a floor drain or to a

drain pipe that is below the level of

the lower baskets wheels, the drain

must be vented; otherwise the water in-

side of the dishwasher may siphon out

during the course of a wash program.

Vent the drain:

Open the dishwasher door.

Cut off the vent cap located at the

right rear of the dishwasher, behind

the filters, as illustrated

Additional note.

Since all Miele dishwashers are

equipped with an odor trap and non-re-

turn valve, the drain hose can be con-

nected directly to the drain pipe as illus-

trated.

If plumbing codes require an external

air gap on the discharge side of the

dishwasher, the following requirements

must be met:

– No part the drain hose should be

higher than 39" (1 mm).

– If installed horizontally, the drain

hose can be up to 12 ft. (3.5 m) long.

If the drain hose is angled upwards

in any way, it cannot be longer than

5 ft. (1.5 m).

– The drain connection should be

made as close as possible to the

dishwasher.

– The internal diameter (7/8" or 22 mm)

of the drain hose should not be re-

duced at any point.

Plumbing

65

1 ... 64 65 66 67 68

Comments to this Manuals

No comments