Miele PG 8172 Operations Instructions download pdf (Page 4)

Safety notes

2.3 Electrical safety

– The electrical safety of this machine is guaranteed only if it is connected to a correctly installed

protective circuit and a residual-current circuit breaker. It is very important that this basic safety

requirement is tested and in case of doubt the installation must be checked by a qualified

electrician.

The manufacturer cannot be held responsible for damage caused by a missing or broken

protective circuit (e.g. electrical shock).

2.4 Safety notes for maintenance and repairs

– Maintenance work and repairs may only be performed by authorised Miele service technicians.

Improper maintenance or repairs may cause significant danger for the user, for which Miele is

not liable.

– When performing installation and maintenance work, disconnect the machine from the power

network. Electricity consumers (heating element, frequency inverter, ...) are under voltage until

the on-site mains disconnector has been operated.

– Only original Miele spare parts may be used for maintenance and repairs. If original spare parts

are not used, the warranty is invalidated.

– A damaged or leaking machine can endanger your safety. In case of defects, switch off the

machine immediately. Switch off the on-site mains disconnector (main switch). Only then is the

machine without power.

– Do not operate a damaged machine. In case of defects resulting from an unknown cause,

switch off the machine, and switch it on again only when the defect has been rectified.

– Contact your installer and/or electrician if the on-site water and/or electricity supply is the cause

of the malfunction.

– Notify an authorised service technician or your retailer if another fault has occurred.

– If the mains cable of this machine is damaged, it must be replaced by the manufacturer or his

Customer Service or another qualified person in order to prevent hazards. The mains cable

must be H07 RN-F type or equivalent.

– Do not spray the machine and the surrounding area (panels, base) using a water hose, steam-

jet air ejector or high-pressure cleaner.

– Ensure that the base of the machine is not flooded when cleaning the floor in order to prevent

an uncontrolled inflow of water.

2.5 General safety notes

– Read through the safety notes and operating instructions in this manual carefully. Retain the

operating instructions for future reference. Miele does not assume liability or warranty in case

of non-adherence to these safety notes and operating instructions.

– Use the commercial dishwasher only after you have read and understood the operating

instructions. Allow the Miele Service Department to provide information about the operation

and functioning of the commercial dishwasher. Always operate the machine as described in

these operating instructions.

– Train the operating personnel as regards handling the machine and inform them about the

safety notes. Repeat the training sessions at regular intervals to prevent accidents.

– For your safety, test the on-site residual-current circuit breaker (FI) regularly by pressing the

test button.

– Close the on-site water stop cock after the work is complete.

– Switch off the on-site mains disconnector after the work is complete.

1 2 3 4 5 6 7 8 9 ... 41 42

Comments to this Manuals

No comments

Miele PG 8172 Operations Instructions Page 4

Comments to this Manuals

Related products and manuals for Dishwashers Miele PG 8172