Miele M 336 EG Installation Manual download pdf (Page 68)

All electrical work should be

undertaken by a suitably qualified

and competent person in strict

accordance with current national

and local safety regulations (BS

7671 in the UK).

Installation, repairs and other work

by unqualified persons could be

dangerous. The manufacturer

cannot be held liable for

unauthorised work.

Ensure power is not supplied to the

appliance until after installation or

repair work has been carried out.

The voltage and connected load are

given on the data plate, visible below

the oven interior, with the door open.

Ensure that these match the household

mains supply. Please quote these data,

and the model and serial number when

contacting Miele.

Connection of this appliance should be

made via a fused connection unit or a

suitable isolator, which complies with

national and local safety regulations,

and the on/off switch should be easily

accessible after the appliance has

been built in.

If the switch is not accessible after

installation (depending on country) an

additional means of disconnection must

be provided for all poles.

For extra safety it is advisable to install

a residual current device (RCD). Please

contact a qualified electrician for

advice.

When switched off there must be an

all-pole contact gap of 3 mm in the

isolator switch (including switch, fuses

and relays acc. to EN 60 335).

Important U.K.

The appliance is supplied for

connection to a 230-240 V, 50 Hz

supply with a 3-core cable.

The wires in the mains lead are

coloured in accordance with the

following code:

Green/yellow = earth

Blue = neutral

Brown = live

WARNING

THIS APPLIANCE MUST BE

EARTHED

When replacing the cable supplied

with another cable or changing the

connection, only cable type

H 05 VV-F or H 05 RR-F with a

suitable cross-sectional area (CSA)

may be used (available from the

Miele Customer Contact Centre).

Electrical connection

68

1 ... 67 68 69 70 71 72

Comments to this Manuals

No comments