Miele T 679 Ci Operations Instructions download pdf (Page 30)

Check and indicator lights:

What to do if . . . Cause . . . Remedy . . .

. . . the “Locked” indicator

light flashes when the ma-

chine is switched on.

The system lock is activated.

The programme cannot be

started.

See section “Electronic system

lock”.

. . . the “Locked” indicator

light comes on during drying.

That is not a fault. The light will go out at the end of

the programme.

. . . the “Drying” indicator

light flashes.

The programme selector was

moved after the beginning of

the programme. The

programme continues to run

normally.

Turn the selector back to its

original position and the light

will go out.

. . . the “Anti-crease/Finish”

light flashes.

There could be a fault.

– Switch the machine off and

on again.

– Select the programme and

press “START”.

Cold surrounding temperatures

below freezing are affecting the

machine (frozen condensed

water).

– Install the appliance in a

warmer room.

If the light continues to flash there

is a problem. Contact Miele

Service Department.

. . . the “Empty out container”

light comes on.

The condensed water container

is full.

Empty the container.

Check that the condensed

water container is correctly

positioned.

. . . the “Clean out airways”

light comes on.

The fluff filters or the condenser

unit are blocked.

– When the programme has

ended, clean the filters (see

section “Cleaning and care”).

– Clean the condenser unit

and check that it is correctly

positioned.

The electronics are registering

that the machine is

underloaded.

Always load the machine to full

capacity for economical drying.

Problem solving guide

30

1 ... 29 30 31 ... 48

Comments to this Manuals

No comments