Miele T8423C Datasheet download pdf (Page 36)

Rear view

a Protruding lid for holding when

moving the machine (see arrows)

b Air inlet vent for cooling the

condenser unit

c Mains connection cable

d External drainage of the condensed

water

e Accessories for connection to a sink

drain outlet

Installation site

,

Make sure the dryer door can be

opened without hindrance after

installation.

Transporting the machine to its

installation site

When moving the machine you can

hold it by the lid where it protrudes to

the rear of the dryer. To manoeuvre the

dryer out of its packing case to its

installation site you will also need to

hold it by the front feet.

Building under a continous worktop /

in a row of kitchen units

The dryer should not be installed next

to a refrigerator or freezer. The warm

air expelled from the rear of the dryer

would increase the temperature

around the refrigerator's/freezer's heat

exchanger causing the compressor to

run continuously. If it is not possible to

install the dryer anywhere else, then

the refrigerator/freezer must be sealed

off from the dryer.

–

A special conversion kit* is required.

The machine lid is replaced by a

coverplate which must be fitted by

suitably qualified person to ensure

electrical safety.

– When installing under a 900/910 mm

high worktop a spacer kit* is required.

– The electric socket must be located

in an accessible position near the

machine.

When built under running times may be

longer.

NOTE:

If you wish to push your machine under

a worktop and there is space to do this

without removing the lid, the conversion

kit is not necessary. Otherwise the

conversion kit is essential.

When building under allow for 625 mm to

include hoses, lid, facia and door. When

building the machine in behind cabinet

doors, ensure that doors are open during

operation for adequate ventilation.

Replacing the lid

If the lid has been removed in order to

fit a cover plate, ensure that, if the lid is

replaced, it fits securely into the rear

holders. Otherwise, it is not properly

secure for transport.

Installation

36

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 51 52

Comments to this Manuals

No comments