Miele T8423C Datasheet download pdf (Page 37)

Aligning the machine

The machine must be perfectly level to

ensure safe and proper operation.

^

The screw feet can be adjusted to

compensate for any unevenness in

the floor.

,

The ventilation slots underneath

the door must on no account be

blocked as this will prevent a

sufficient intake of cold air.

Room in which the dryer is located

Air taken in for use in the drying

process will be warm when it is

expelled from the front of the dryer. This

expelled air heats up the air in the

room. It is therefore very important to

ensure that the room is adequately

ventilated, particularly if the dryer is

located in a small room. Otherwise

running times and energy consumption

could be increased.

Washer-dryer stack

The tumble dryer can also be

combined with a Miele washing

machine in a washer-dryer stack. To do

this the appropriate stacking kit* (WTV)

to match your washing machine is

required.

A washer and dryer should never be

stacked without using the proper

stacking kit. Doing so is extremely

dangerous, as the dryer may vibrate off

of the washing machine during use.

,

All parts marked * are available

from the Miele Spare Parts or Sales

Departement, and must be fitted by

a suitably competent person

according to the instructions

supplied with the kit.

Before moving the machine again

After each use a small quantity of

condensed water will collect in the area

of the pump. This water can run out, if

the machine is tipped up when it is

being moved. We therefore recommend

that you run the "Cool air" programme

for approximately 1 minute before

moving the machine. Any remaining

condensed water will then be fed into

the condensed water container or out

through the drain hose.

Installation

37

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 51 52

Comments to this Manuals

No comments