Miele PW 6055 Plus Service Manual download pdf (Page 57)

Electrical connection

This machine is supplied with a

connection cable without a plug for

connection to a suitable connection

socket or isolator switch.

,

The voltage, rated load and fuse

rating are given on the data plate.

Please ensure these match the site

mains supply.

This machine must be connected to the

electricity supply in accordance with

local and national safety regulations

(BS 7671 in the UK).

Connection to the electricity supply

must only be carried out by a suitably

qualified and competent person.

Connection should be made via a

suitable connection socket or isolator

which complies with local and national

safety regulations and which is easily

accessible for disconnecting the

machine from the electrical supply.

Provision must be made on site to

switch off all poles. Switches with a

minimum all-pole contact gap greater

than 3 mm are suitable for isolating the

machine. These include circuit

breakers, fuses and relays (IEC/EN

60947).

,

If the machine is disconnected

from the electricity supply ensure

adequate measures are taken to

ensure that the machine cannot be

reconnected to the electricity supply

until all work has been carried out.

Should the connection cable require

replacing or changes be necessary in

the electrical installation including

checking and/or replacing the fuse

please make sure this is done by an

approved electrician to ensure

compliance with all local and national

electrical safety requirements.

For extra safety, it is advisable to

protect the machine with a suitable

residual current device (RCD) with a

trip current of 30 mA.

,

This machine can be converted

to a different voltage. Please

observe the switching instructions

given on the wiring diagram.

Conversion may only be carried out

by a Miele authorised service dealer

or Miele technician.

If converted the heater rating must

also be adapted.

,

The machine must be

permanently connected to the

electricity supply so that the door

can be opened. For this reason, it

must not be connected to devices

such as timers which would switch it

off automatically.

WARNING

THIS MACHINE MUST BE

EARTHED

Installation and connection

57

1 2 ... 52 53 54 55 56 57 58 59 60

Comments to this Manuals

No comments