Miele W 833 Operations Instructions download pdf (Page 30)

What to do if, . . . Cause . . . Remedy . . .

. . . one of the following

lights is flashing:

– “Soak/Pre-wash”

– “Main wash”

There is a fault.

Start the programme again. If

the light starts flashing again,

call the Service dept.

. . . the “Rinses/Rinse hold”

light flashes quickly?

There is a fault.

. . . the “Rinses/Rinse hold”

light flashes slowly?

The spin speed selector has

been set to “Rinse hold”.

Select a spin speed or “Without

final spin”.

. . . the “Drain/Final spin”

light is flashing:

The final spin has not taken

place. The machine detected

an imbalance.

– Loosen the laundry load.

– Turn the programme selector

to “Spin”.

– The spin speed appropriate

for the programme should be

selected.

. . . the “ON” indicator light

is flashing:

Programme locking is activated.

There was an attempt to alter

the programme.

Reselect the programme

originally chosen.

. . . the washing is not spun

satisfactorily:

The spin speed selected was

too low.

Select a higher spin speed next

time.

The load was not distributed

sufficiently evenly in the drum.

Laundry was spun at a reduced

speed to protect the machine.

Mix large and small items in a

load to avoid imbalance.

The fluff filter is clogged. Clean the fluff filter.

. . . the machine shakes

during the spin cycle:

The four feet are not resting

evenly on the floor.

Level the machine (See Section

on Installation).

. . . in spite of adequate

water supply the water flows

slowly into the machine:

The filters in the water inlet

system are blocked.

Clean the water inlet filters.

Problem solving guide

30

1 ... 29 30 31 ... 48

Comments to this Manuals

No comments