Miele W 833 Operations Instructions download pdf (Page 35)

Installation

Installation surface

Experience has shown that a concrete

floor is the most suitable installation sur-

face for a washing machine. Concrete

floors are far less prone to vibration dur-

ing the spin cycle than wooden floor-

boards or a surface with "soft" proper-

ties.

Please note the following points:

The machine must be level and se-

curely positioned.

To avoid vibrations during spinning,

the machine should not be installed

on soft floor coverings.

If installation must be on a wooden

joist floor, we recommend the use of

a plywood base at least 30 mm thick

and 59 x 52 cm wide. Ideally, the

base should be large enough to

span several joists and should be

bolted to the joists and not only to

the floorboards. Check for the

presence of pipes and cables first.

The most stable part of a floor is

usually in the corner.

If the machine is installed on a

raised plinth, it must be secured

against slippage during spin using

retaining clips (available from the

Miele Spare Parts Dept).

Installation

Lift the machine from its packaging

base and move it to its site. Please

note:

Do not lift the machine by the drum

door.

Ensure that the machine feet and the

floor are dry to prevent the machine

from slipping during the spin cycle.

Removing the transit fitting

Using a pipe wrench turn the left-

hand transit bar 90°.

Turn the right-hand transit bar 90°.

Installation

35

1 ... 34 35 36 ... 48

Comments to this Manuals

No comments