Miele 36160111USA Installation Manual download pdf (Page 55)

Accessing the RemoteVision

control panel

^

Touch the access button "p"soit

turns yellow.

^

Touch the sensor button for any

temperature zone so it turns yellow.

^ Note the position of the X button, but

do not touch.

^ Touch the access button "p" again so

it turns white.

Only the access button "p" is visible.

^ Place one finger on the position of

the X button and hold (the X button

will not be visible).

^

While holding down the X button,

press the access button "p" once.

Keep holding the X button down until

the following appears in the display

(approx. 5 seconds).

Access to the Custom settings mode is

now active for approximately 10

seconds.

^

Tap the X button until ; appears in

the display.

^

Touch the access button "p"to

confirm.

See the table on the following page for

a description of each setting in the

display.

^

Use the Y or X buttons to select the

RemoteVision options.

The module has been connected to

the network when ; # appears in the

display.

If ; # does not appear, refer to the

"Network options" section of the

XKM 2000 Installation Instruction

manual.

^ Press and hold the access button "p"

for 2 seconds to confirm the change.

^ To return to the main menu, tap the X

button until a solid ; - appears in the

display.

^

Press the access button "p"to

confirm.

^

Tap the X button until a ; appears in

the display.

^

Touch the access button "p".

You have left the Custom settings

mode.

When you are in the Custom settings

mode the door alarm is turned off

automatically. Once the door is

closed it is reactivated.

RemoteVision (optional accessory)

55

1 ... 54 55 56 57 58 59 60

Comments to this Manuals

No comments