Miele CS 1012-1 Installation Manual download pdf (Page 31)

,

Repairs to the gas and electrical

components of this appliance must

only be carried out by a suitably

qualified and competent person to

ensure safety (Gas Safe registered

in the UK). Repairs and other work

by unqualified persons could be

dangerous. The manufacturer

cannot be held liable for

unauthorised work.

What to do if ...

... the burner does not ignite when

the hob is being used for the first

time or after a long period of not

being used.

There could be an air lock in the gas

pipe. You may need to make several

attempts before the burner ignites

successfully.

... the in-operation and residual heat

indicators are flashing at the same

time.

–

There has been a power cut.

–

Re-ignition was not possible.

–

The gas supply has been

interrupted.

Turn all the controls clockwise to the "ß"

position. You can then operate the

appliance as normal.

If the problem persists, disconnect the

appliance from the electricity supply for

a few seconds.

... there has been a power cut.

Turn all the controls clockwise to the "ß"

position. You can then operate the

appliance as normal.

If the problem persists, disconnect the

appliance from the electricity supply for

a few seconds.

... the burner does not ignite after

several attempts.

Disconnect the appliance from the

electricity supply for a few seconds. If

the problem persists, check whether

– the burner is assembled correctly.

– the gas supply tap is turned on.

– the burner is dry and clean.

– the flame slits are dry and

unblocked.

... the gas flame goes out after being

lit.

The flames need to touch the ignition

safety device so that it heats up

sufficiently.

If the flames do not touch the ignition

safety device, check that

–

the burner components are

assembled correctly.

–

there is no soiling on the ignition

safety device. If there is, remove it

carefully (see "Cleaning and care").

Problem solving guide

31

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 55 56

Comments to this Manuals

No comments