Miele PW 5065 Service Manual download pdf (Page 67)

3.21 Fault code F56, no spin

PW 6055, PW 6065

Symptom

Final spin speed < 400 rpm even though the desired speed is at least 450 rpm.

Fault registered via tachogenerator.

Cause

Final spin speed < 400 rpm even though the desired speed is at least 450 rpm.

Remedy

A Check dispensed quantities, see Fault code F16, excess foam, 080 3.10.

A Check the drive, see Drive failure, 070 3.1.

3.22 Fault code F63, water path control unit

Symptom

In normal operation mode the display shows Technical fault.

The solenoid valve is closed and the programme interrupted. The drain pump is

activated for 120 s.

Cause

Water path control system faulty.

The power-programme module (ELP) cannot register a valid position of the water

path control unit within approx. 80 s of it being switched on.

Note

Water intake monitoring is not active if a valid position of the water path control

unit cannot be registered.

Check the water path control system

A Check the water path control system circuit for an open or short circuit, and

correct insulation.

Descriptive Technical Documentation

DTD no. 511-6055 080-19

1 2 ... 62 63 64 65 66 67 68 69 70 71 72 ... 95 96

No comments

Miele PW 5065 Service Manual Page 67