Miele G 7823 Operations Instructions download pdf (Page 46)

,

All electrical work must be

carried out by a suitably qualified

and competent person in

compliance with local and national

safety regulations.

^

Connection should be made via a

suitable isolator which complies with

local and national safety regulations

and the on-off switch should be

easily accessible for servicing.

WARNING

THIS APPLIANCE MUST

BE EARTHED

^ For technical data see the data plate

or wiring diagram supplied.

The machine must only be operated

with the voltage, frequency and fusing

shown on the data plate.

The data plate (with test certification

VDE, DVGW etc.) is located on the rear

of the machine and also behind the

plinth panel below the protective plastic

cover.

The wiring diagram is secured to the

inner side below the protective plastic

cover.

Removing the plinth panel and the

protective plastic cover:

,

Isolate the machine from the

power supply.

^ Holding the plinth panel at both

sides, pull gently outwards from

beneath a and take it out b.

^ To remove the protective plastic

cover unscrew the 2 screws (left and

right) c.

To reassemble:

^

Refit the protective plastic cover and

the plinth panel in the reverse order

to which they were removed.

See also the installation diagram

supplied.

Bonding connection

There is a screw connection point

marked with the earth symbol (8)atthe

back of the machine, to which the earth

bonding must be connected.

Electrical connection

46

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 52

Comments to this Manuals

No comments