Miele W 4449 WPS LIQUIDWASH Operations Instructions download pdf (Page 57)

Installation surface

A concrete floor is the most suitable

installation surface for a washing

machine, being far less prone to

vibration during the spin cycle than

wooden floorboards or a carpeted

surface.

Please note the following points:

^

The machine must be level and

securely positioned.

^

To avoid vibrations during spinning,

the machine should not be installed

on soft floor coverings.

If installing on a wooden joist floor:

^ We recommend a plywood base (at

least 59x52x3 cm). The base should

span several joists and be bolted to

the joists and not only to the

floorboards. Check for the presence

of pipes and cables first.

If possible, install the machine in a

corner, as this is usually the most stable

part of the floor.

,

If the machine is installed on a

raised plinth, it has to be secured

against slippage during spinning

using retaining clips (available from

the Miele Spare Parts Dept).

Transporting the machine to its

installation site

To manoeuvre the machine out of its

packing case to its installation site, hold

it by the front feet as well as by the

edge of the lid where it protrudes to the

rear of the washing machine.

,

Ensure that the machine feet and

the floor are dry to prevent the

machine from slipping during the

spin cycle.

Removing the transit fittings

^

To remove the left and right covers

1. Use a screwdriver to prise out the

cover as illustrated.

2. Pull the cover forwards to remove.

Installation and connection

57

1 ... 56 57 58 ... 80

Comments to this Manuals

No comments