Miele G 7804 Operations Instructions download pdf (Page 46)

With the aid of the following explanatory

notes, minor faults can be corrected

without contacting the Miele Service

Dept.

Any work on the electrical components

of the machine should only be carried

out by a suitably qualified and

competent person in accordance with

local and national safety regulations.

Unauthorised repairs could be

dangerous.

Faults / possible causes

The machine does not start

– The door is not properly closed.

– The plug is not properly inserted in

the socket.

– The fuse is defective / has blown.

A few minutes after switching on, the

p / 6 indicator light flashes (fault

code F..E appears in the display)

–

The stopcocks are closed.

–

The filters in the water inlet hose are

dirty.

–

The water pressure is too low.

^

Turn the programme selector to the

STOP position f (the fault code

goes out).

^

Switch the machine off (press I-0).

^

Open the stopcocks or clean the

filters (see "Cleaning and Care").

^

Switch the machine on again and

reselect the programme.

The wash cycle finishes too early

and the p / 6 indicator light flashes

(fault code F A appears in the

display).

–

The drain hose is kinked.

–

The drain pump is blocked

^

Turn the programme selector to the

STOP position f (the fault code

goes out).

^

Switch the machine off (press I-0).

^

Straighten the hose and check/clean

the drain pump.

^ Switch the machine on again, drain

the water away and start the

programme again (see DRAIN and

"Switching on").

Water in the wash cabinet does not

heat up; the programme takes too

long (a fault code appears in the

display: F01 - F02)

This machine has a resettable heater

limiter which will switch off the heaters if

they over-heat. This could be caused

for example, by large articles covering

the heating elements or if the filters in

the wash cabinet are blocked.

^

Remove the cause of the fault.

^

Take off the service panel (see

"Electrical connection").

^

Press the reset button on the heater

limiter (reddish brown) located on the

left- hand side of the plinth.

If this switch trips again contact the

Miele Service Department.

Correcting minor faults

46

1 ... 45 46 47 ... 60

Comments to this Manuals

No comments