Miele Microwave Oven Operations Instructions download pdf (Page 45)

Before connecting the appliance,

ensure that it has not been

damaged in any way. Do not use a

damaged appliance.

The appliance is supplied with a mains

cable and moulded plug ready for

connection to an AC single phase

220-240 V 50 Hz supply.

Fuse protection is to be conducted as

follows: Connection to an earthed

power socket, protected with 10 A-L

automat or fuse 10 A.

Connection must only be made via a

suitable switched socket. The electrical

system must comply with VDE0100.

The appliance should be positioned so

that the plug is accessible.

Connection should be made via a

suitable switched socket, or via a

suitable isolator, which complies with

national and local safety regulations,

and the on/off switch should be easily

accessible after the appliance has

been installed. If it is installed via an

isolator switch, connection must be

carried out by an electrician.

When switched off, there must be an

all-pole contact gap of 3 mm in the

switch (including switch, fuses and

relays).

The voltage, rated load and fuse rating

are given on the data plate situated at

the front of the oven interior. Please

ensure these match the household

mains supply.

If the supply cord is damaged, it must

be replaced by a Miele approved ser

-

vice technician to avoid a hazard.

Do not connect the machine to an

inverter such as those used with an

autonomous energy source e.g. Solar

power. When switched on, peak loads

in the system can cause the safety

switch off mechanism to be triggered.

This can damage the electronic unit.

The machine must not be used with

so-called Energy saving devices

either. These reduce the amount of

energy supplied to the machine,

causing it to overheat.

Electrical connection

45

1 ... 44 45 46 47 48 49 50 51 52

Comments to this Manuals

No comments