Miele H 373 Pyrolytic Operations Instructions download pdf (Page 72)

Electrical connection UK, IRL, ZA

All electrical work should be under-

taken by a suitably qualified and

competent person in strict accord-

ance with national and local safety

regulations.

Installation, repairs and other work

by unqualified persons could be

dangerous. The manufacturer can-

not be held responsible for unauth-

orised work.

Ensure power is not supplied to the

appliance while installation or repair

work is being carried out.

The voltage, rated load and fusing

are given on the data plate, visible

below the oven interior, with the oven

door open. Ensure that these match the

household mains supply. Please quote

these data, and the model and serial

number when contacting the Miele Ser-

vice dept.

Connection of this appliance should be

made either via a fused connection unit

(rated load under 3000 W), or via a suit-

able isolator (rated load over 3000 W),

which complies with national and local

safety regulations, and the on/off

switch should be easily accessible

after the appliance has been built in.

If the socket is not accessible after in-

stallation (depending on country) an ad-

ditional means of disconnection must

be provided for all poles.

For extra safety it is advisable to install

a residual current device with a trip cur-

rent of 30 mA (in accordance with DIN

VDE 0664, VDE 0100 Section 739).

When switched off there must be an all-

pole contact gap of 3 mm in the isola-

tor switch (including switch, fuses and

relays acc. to EN 60 335).

Important U.K.

This appliance is supplied with a

3-core cable for connection to a single

phase 230-240 V 50 Hz supply.

The wires are coloured in accordance

with the following code:

Green/yellow = earth

Blue = neutral

Brown = live

In other countries check these details

with your supplier.

WARNING

THIS APPLIANCE MUST BE

EARTHED

Oven with integrated hob controls

"E" model

This is not available in all countries.

For some countries the version of the

oven with integral hob controls is sup-

plied for connection to a 3N ~ 400 V

power supply.

Any adaptations must on be carried out

in consultation with the relevant Miele

Service Dept.

Possible combinations:

Miele built-in ovens may only be com-

bined with hobs and their respective

control units as specified by Miele for

use with that oven.

Contact your Miele Dealer for further in-

formation on suitable combinations.

Electrical connection UK, IRL, ZA

72

1 ... 71 72 73 ... 84

Comments to this Manuals

No comments